Triboelectric separation technology for removing inorganics from non-metallic fraction of waste printed circuit boards: Influence of size fraction and process optimization

Removing inorganics from non-metallic fraction (NMF) of waste printed circuit boards (WPCBs) is an effective mean to improve its usability. The effect of size fraction on the triboelectric separation of NMF of WPCBs was investigated in a lab triboelectric separation system and the separation process was optimized in this paper. The elements distribution in raw NMF collected from typical WPCBs recycling plant and each size fraction obtained by sieving were analyzed by X-ray fluorescence (XRF). The results show that the main inorganic elements in NMF are P, Ba, Mn, Sb, Ti, Pb, Zn, Sn, Mg, Fe, Ca, Cu, Al and Si. The inorganic content of each size fraction increased with the size decreasing. The metal elements are mainly distributed in -0.2mm size fraction, and concentrated in middle product of triboelectric separation. The loss on ignition (LOI) of positive product and negative product is higher than that of the middle product for the -0.355mm size fraction, while the LOI presents gradually increasing trend from negative to positive plate for the +0.355mm size fraction. Based on the separation results and mineralogical characterizations of each size fraction of NMF, the pretreatment process including several mineral processing operations was added before triboelectric separation and better separation result was obtained.