The purpose of this study was to investigate the effects of temperature, oxidation time, presence of water, pH, type of buffer and form of substrate used on cholesterol oxidation. Microcrystalline cholesterol films, both solid and melted, and aqueous suspensions of film fragments were used as substrates. Use of dispersing agents was avoided. Quantitative analysis of the unaltered substrate and the products of its autoxidation was carried out by gas chromatography over the course of oxidation. Solid cholesterol films were found to be resistant to autoxidation in the dry state. However, when heated at 125 degrees C, a sudden increase in oxidation rate occurred at a point coinciding with the visible melting followed by a plateau of the oxidation rate. All of the autoxidation products formed underwent further decomposition. Film fragments of cholesterol oxidized at a faster rate in aqueous suspensions than when oxidized in the dry state. In aqueous suspensions, the differences in the resistance of cholesterol to oxidation were not significant within the pH range 6.0-7.4, except for the early stages of oxidation. The 7-ketocholesterol/7-hydroxycholesterol ratio dropped significantly with increasing pH. However, at all pH levels tested, this ratio remained relatively constant during the 6 h of heating. While the 7 beta-hydroxycholesterol/7 alpha-hydroxycholesterol ratio was not affected by pH in the range of 6.0-7.4, at pH 7.4 a high preference was observed for the cholesterol beta-epoxide over its alpha-isomer.(ABSTRACT TRUNCATED AT 250 WORDS)